Pre-Swaged kits (ready made balustrade wires) come ready made to length with the fittings Hydraulically Pressed (swaged) to the ends of the wire. These are the easiest kit to use and no special tools are required. When puchasing this type of kit we will require the inside to inside post measurements of your two end posts. You can still pass the wire through any centre post by drilling an 8mm hole.

We recommend using Pre-Swaged Kits with Saddles for steel posts and Pre-Swaged Kits with Lag Screws for timber posts.

Each wire has +- 30mm from the measurement provided. If your posts are not 100% vertical you should supply the average length for us to make the wires too.

You will also need to purchase the wire to go with these kits as a separate item. To calculate the wire required multiply the quantity required by the length of the wire. Eg:
11 x 1554 = 17094
11 x 2459 = 27049
11 x 5654 = 62194
Total wire = 106 meters

You will also need to type the lengths and quantities required into the comments section during the checkout process.

Make sure you click on the product details link for each kit to find out more information about the kit.